The Federal Aviation Administration has paused the installation of new routers and disabled a function on equipment linked to a nationwide ground stop, the agency said on Tuesday. The decision followed a request from 13 Democratic senators for the FAA to suspend further replacements while the disruption is investigated.

The FAA said it believed disabling the function on the originating Juniper routers had addressed the initial cause. It also turned off the same function on more than 60 other Juniper routers in its telecommunications network as a precaution. The agency did not say in its Tuesday statement that the investigation had concluded.

Friday’s ground stop lasted about four hours and was followed by more than 10,000 flight cancellations. The disruption continued to affect US air travel after the order ended. According to the report, it was only the second such sweeping FAA order since the September 11, 2001 attacks.

Upgrades under investigation

In a statement on Sunday, the FAA said its initial investigation pointed to upgrades at two sites: a radar location in Amarillo, Texas, and a radio communications location in El Dorado, Arkansas. During the ground stop, the agency said an upgrade had made its system unstable, sending a flood of data to other equipment and disrupting aircraft communications and radar feeds.

The FAA said it ordered a nationwide halt to outbound flights as a precaution. Transportation Secretary Sean Duffy told ABC on Sunday that safety was his foremost responsibility and addressed inconsistencies involving communications between air traffic controllers and pilots, as well as data feeds.

The FBI said on Tuesday that it was investigating the incident with the Department of Transportation, the FAA and L3Harris, the agency’s network service provider. The bureau said it had not taken possession of any equipment.

Senators question replacement programme

L3Harris had been replacing older copper wiring with fibre-optic lines and swapping old routers for devices made by Juniper Networks. The FAA said on Sunday that the transition away from copper had been under way for years because the old wires were being disconnected as they became obsolete.

In their letter, the senators asked the FAA to halt plans to replace more than 3,000 additional routers. Citing information provided to their offices by L3Harris, they said the copper-to-fibre transition involved converting 3,648 routers to Juniper devices. Their understanding was that 400 had been installed and 69 were operational.

The Senate Commerce Committee lawmakers, led by Maria Cantwell, argued that outstanding safety and reliability concerns needed to be addressed before installations expanded. Their request came earlier on Tuesday, before the FAA announced its pause.

The router dispute comes alongside a funding disagreement over the FAA’s technical infrastructure. The White House has asked Congress for $50bn to complete an overhaul, while Democratic lawmakers have resisted the request, arguing that the administration had used only a fraction of the $12.5bn it was authorised to spend the previous year.